Moxa MGATE EIP3270I Manuel d'utilisateur télécharger pdf (Page 21)

MGate EIP3000 Series User’s Manual Hardware: EIP3270, EIP3270I

Jumpers

SW 2 SW 1

The DIP switches are located beneath the DIP switch panel on the side of the unit.

To add a 120 Ω termination resistor, set switch 3 on the port’s assigned DIP switch to ON; set

switch 3 to OFF (the default setting) to disable the termination resistor.

To set the pull high/low resistors to 150 KΩ, set switches 1 and 2 on the port’s assigned DIP switch

to OFF. This is the default setting.

To set the pull high/low resistors to 1 KΩ, set switches 1 and 2 on the port’s assigned DIP switch to

ON.

Switch 4 on the port’s assigned DIP switch is reserved.

ATTENTION

Do not use the 1 KΩ pull high/low setting on the MGate EIP3000 when using the RS-232 interface.

Doing so will degrade the RS-232 signals and reduce the effective communication distance.

4-4

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Pas de commentaire

Moxa MGATE EIP3270I Manuel d'utilisateur Page 21