Moxa AWK-1100 Manuel d'utilisateur télécharger pdf (Page 36)

AirWorks AWK-1100 User’s Manual Web Console Configuration

System Log

System events can be logged to the on-board RAM of the AWK-1100 (Local log) or sent to a

remote computer on which an SNMP trap monitor program runs (Remote log by SNMP trap).

See the next subsection for more information about SNMP trap settings.

The system events are divided into the following categories:

General: system and network connectivity status changes.

Built-in AP: wireless client association and WEP authentication status changes.

MIB II traps: Cold Start, Warm Start, Link Up, Link Down and SNMP Authentication Failure.

RADIUS user authentication: RADIUS user authentication status changes.

NOTE

The SNMP Authentication Failure trap is issued when using an incorrect community string to

manage the AP via SNMP and the SNMP MIB II OID, snmpEnableAuthenTraps, is enabled

(disabled by default).

SNMP

The SNMP (Simple Network Management Protocol) functionality can be disabled, and you can

specify the name (used as a password) of the read-only and read-write community. In addition, up

to 5 SNMP trap targets can be set in the SNMP Trap Table.

To specify a trap target :

Type the IP address of the target host.

Type the Community for the host.

Select the corresponding check box next to the IP address text box.

3-23

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Moxa AWK-1100 Manuel d'utilisateur Page 36