Moxa ONCELL G2110-T Manuel d'utilisateur télécharger pdf (Page 56)

OnCell G2100 SeriesI User’s Manual OnCell Configurator

3-36

Setting Modem Defaults

The following instructions illustrate how to use Configurator to load the factory default settings

into the OnCell G2100 Series modem.

1. Connect the RS-232 port of the OnCell G2100 Series modem to a host PC. On the OnCell

G2150I, make sure the RS-232 port is connected and DIP switch 1 is set to ON.

ATTENTION

The RS-232 connector uses the standard pinouts. A direct male DB9 to female DB9 cable, such as

Moxa’s CBL-F9M9-150 (100 cm) or CBL-F9M9-20 (20 cm), can be used to connect to a PC’s

serial port. If you use a USB-to-serial product to configure the OnCell G2100 Series modem, we

strongly recommend using Moxa’s UPort 1110. Other USB-to-serial products may cause

unexpected errors when configuring the OnCell G2100 Series modem.

2. Start OnCell Configurator and select the Create a new Configuration File from

Configurator option.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 104 105

Pas de commentaire

Moxa ONCELL G2110-T Manuel d'utilisateur Page 56