Moxa IMC-21-M-ST Guide d'installation télécharger pdf (Page 7)

- 7 -

Grounding Moxa Industrial Media

Converter

Grounding and wire routing help limit the effects

of noise due to electromagnetic interference

(EMI). Run the ground connection from the right

most connector of the 3-contact terminal block to

the grounding surface prior to connecting

devices.

ATTENTION

This product is intended to be mounted to a well-grounded

mounting surface such as a metal panel.

Wiring the Power Inputs

The two left-most contacts of the 3-contact terminal block connector on IMC’s

top panel are used for IMC’s DC or AC inputs. Top and front views of one of

the terminal block connectors are shown here.

STEP 1: Insert the negative/positive DC wires

into the V-/V+ terminals.

STEP 2: To keep the DC wires from pulling

loose, use a small flat-blade screwdriver to

tighten the wire-clamp screws on the front of the

terminal block connector.

STEP 3: Insert the plastic terminal block

connector prongs into the terminal block receptor,

which is located on IMC’s top panel.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Moxa IMC-21-M-ST Guide d'installation Page 7