Moxa AWK-5222-EU Manuel d'utilisateur télécharger pdf (Page 10)

AWK-5222 User’s Manual Introduction

1-6

ATTENTION

When the LEDs for STATE (Green), FAULT, WLAN1 and WLAN2 all light up simultaneously

and blink at one-second intervals, it means the system failed to boot. This may be due to improper

operation or uncontrollable issues, such as an unexpected shutdown during firmware update. To

recover the firmware, refer to “Firmware Recovery” in Chapter 6.

Beeper

The beeper signals that the system is ready with two short beeps.

Reset Button

The RESET button is located on the top panel of the AWK-5222. You can reboot the AWK-5222

or reset it to factory default settings by pressing the RESET button with a pointed object such as

an unfolded paper clip.

y System reboot: Hold the RESET button down for under 5 seconds and then release.

y Reset to factory default: Hold the RESET button down for over 5 seconds until the STATE

LED starts blinking green. Release the button to reset the AWK-5222.

AUX1

AUX2

RESET button

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

Pas de commentaire

Moxa AWK-5222-EU Manuel d'utilisateur Page 10