Moxa AWK-4131-M12-EU-T Guide d'installation télécharger pdf (Page 6)

- 6 -

STEP 1:

Attach the wall-mounting kit

with M4 screws, as shown in

the diagram below.

STEP 2:

Mounting the AWK-4131 on the wall

requires 4 screws. Use the AWK-4131

device, with wall-mounting kit

attached, as a guide to mark the correct

locations of the 4 screws. The heads of

the screws are recommended to be

between 5.5mm and 8.5 mm in

diameter, and the shafts should not

more than 5.0 mm

in diameter, as

shown in the figure.

Do not screw the screws all the way in to the wall—leave a space of about

2 mm to allow room for sliding the wall-mounting kit between the wall and

the screws.

ATTENTION

You can test the screw head and shank

size by inserting the screw

into one of the keyhole shaped apertures of the wall mounting

plates before it is screwed into the wall.

STEP 3:

Once the screws are fixed into the wall, insert the four screw heads

through the large opening of the keyhole-shaped apertures, and then

slide the AWK-4131 downwards, as indicated to the right. Tighten the

four screws for added stability.

ATTENTION

To avoid environmental vibration or shock, you can consider a

robust installation with four bigger screws, which the shafts are

between 7.0 mm and 8.5 mm in diameter, and fix the AWK-4131

onto wall directly and tightly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Moxa AWK-4131-M12-EU-T Guide d'installation Page 6