Moxa AWK-4131-M12-EU-T Guide d'installation télécharger pdf (Page 11)

- 11 -

Installation

1. Refer to the pin assignment and solder wires with ;

2. Then assemble , , , and  in order;

3. Test the plug to ensure the quality.

RS-232 Connection

The AWK-4131 has one RS-232 (8-pin RJ45) console port located on the

bottom panel. Use either an RJ45-to-DB9 or RJ45-to-DB25 cable to

connect the Moxa AWK-4131’s console port to your PC’s COM port. You

may then use a console terminal program to access the AWK-4131 for

console configuration.

Console Pinouts for 10-pin or 8-pin RJ45

10-Pin Description 8-Pin

1 -----

2 DSR 1

3 RTS 2

4 GND 3

5 TxD 4

6 RxD 5

7 DCD 6

8 CTS 7

9 DTR 8

10 -----

NOTE 3. The pin numbers for male DB9 and DB25 connectors, and

hole numbers for female DB9 and DB25 connectors are

labeled on the connector. However, the numbers are

typically quite small, so you may need to use a magnifying

glass to see the numbers clearly.

4. The pin numbers for both 8-pin and 10-

pin RJ45 connectors

(and ports) are typically not labeled on the connector (or

port). Refer to the Pinout diagram above to see how RJ45

pins are numbered.

LED Indicators

The front panel of the Moxa AWK-4131 contains several LED indicators.

The function of each LED is described in the table below.

LED Color State Description

PWR Green On Power is being supplied

(from power input 1 or 2, or PoE).

Off Power is not being supplied

FAULT Red Blinking

(slow)

Cannot get an IP address from the DHCP

server (interval: 1 sec)

1 2 ... 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Moxa AWK-4131-M12-EU-T Guide d'installation Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles et répétiteurs Moxa AWK-4131-M12-EU-T